Alpine MC10 Manual do Utilizador descarregar pdf (Página 8)

MC1 Add on

MC10

APN Marine Head Unit

Mesh Network ON

* When MESH NET is turned ON in the program menu of a

display unit, it becomes a signal repeater for extending the

MC10 system range.

MC10 Marine Commander System

2.4GHz

Wireless

2.4GHz

Wireless

Transceiver

Mesh Network OFF

.FTI/FUXPSL0QFSBUJPO

* If for some reason you want to pair an MC10 display unit with a different

MC10 system than the one it was purchased with (just like adding an MC1

Commander) follow the instructions below:

1. Power on the MC10 system that you want to add the additional MC10

display unit to

2. Connect power and ground wires of new MC10 display unit

3. Wait at least 20 seconds, then enter the Program Menu (see Program

Menu Example)

4. Go to the RESET MC1 option, then press ENT button

5. MC10 display unit will reset itself (including factory default settings) and

display will show ADD MC1 like in step 3 of the previous section (MC1

Add-on Commander Pairing Procedure)

6. Follow the remaining steps of the previous section to complete this

operation

.$%JTQMBZ6OJU3F1BJSJOH1SPDFEVSF

To install an MC1 Add-on Commander in a new location that is outside the MC10 system

range:

1. Go to the MC10 system display unit that is closest to the new location

2. Turn Mesh Network ON in the program menu, then exit program menu

3. Follow the MC1 Add-on Commander Pairing Procedure on page 6 to complete

the new installation

1 2 3 4 5 6 7 8 9

Sem comentários

Alpine MC10 Manual do Utilizador Página 8